Elo TouchSystems ET1566L-7SWC-1 - Manual (Page 12)

2-7
Mounting Your Touchmonitor
N OTE : You will need a 6mm allen socket and torque wrench (Hex) to attach the mounting
brackets.
Your panel mount touchmonitor comes with 6 mounting brackets (and 6
screws). You will need 6 brackets to mount your touchmonitor. Two brackets
attach to the top and bottom and one on each side.
To mount your touchmonitor to a panel, follow the steps below:
1 Prepare the opening in the panel (307mm x 398.2mm/12.08" x 15.68"). See
page C-36. Mounting panel thickness must not exceed 13mm.
2 Disassemble the 6 brackets and NEMA frame.
3 Verify that your touchmonitor will clear the opening as you attempt to front
mount it. The opening will be covered by the bezel flanges.
4 Mount the touchmonitor from the front side of the opening in the supporting
panel and temporarily secure it.
5 From the back of the panel opening, slip the NEMA frame over the rear
cover. Attach the 6 brackets into the slots. Use 2 brackets on top and bottom
and 1 on each side.
6 To secure the touchmonitor, turn the screws clockwise until a firm
contact is made with the NEMA frame. To assure a “flat” mount, screws
should be tightened “cris-cross” and not sequentially, i.e. tighten the
upper left corner screw first then the lower right screw. Torque screws
to 35 in lbs. (4 Nm).