ARM Electronics JHD - Manual (Page 39)

JPEG2000 Stand alone DVR User Guide
- 39 -
[CONNECTION SETUP]
Use  to select and [+] [-] or J.Shuttle to change the value.
1.[TIMEOUT]
Set up the remote connection response time, if the client does not receive
responses from the DVR for certain duration, the client will disconnect the
connection and try again. The setup range is from 1 millisecond to 12,750
seconds.
2.[RETRY COUNT]
Set up the times that the client tries to reconnect to the DVR. The client will quit
trying to reconnect to the DVR after all the attempts fail. The setup range is
from 0 to 20 attempts.
[DHCP SETUP ]
1.[DHCP MODE]
Press ENTER to switch DHCP to [AUTOMATIC].
2.[DETECT IP]
Move the curor to DETECT IP and press ENTER to start. Press MENU to
cancel the detection.
[EVENT SERVER SETUP]
1.[IP ADDRESS]
IP Address of PC that executes EVENT SERVER PROGRAM.
2.[IP PORT]
PORT of PC that executes EVENT SERVER PROGRAM.
3.[EVENT SERVER TYPE]
It is the way to transmit data to SERVER By "OFF", "EVENT", "MINUTE“,
In case Event happens from DVR.
"EVENT“: It transmits by the number of EVENT.
"MINUTE“: It transmits each scheduled time.
4.[INTERVAL]
If EVENT SERVER TYPE is "EVENT" User can select from 1~512.
If EVENT SERVER TYPE is "MINUTE“, User can select from 1 ~ 60 mins.
5.[EVENT GMT TYPE]
User can set currently installed location(DVR) of GMT.