Atlantic Water Gardens SH1450 - Manual (Page 5)

• In case of excessive vibration, unusual noise or odor, turn off the power
immediately and consult your nearest dealer.
Motor Protection System
• The pump has a built-in motor protection system. The following reasons
may cause the pump to stop automatically regardless of water level.
Motor overheating
Excessive current
Change in voltage polarity
Open-phase operation or operation under constraint
• Repeating cycles of stopping and restarting will damage the water
pump. Do not continue operation at low lift, low water level, or while
the inlet is clogged with debris. Not only will performance suffer, but
also such conditions may cause noise, heavy vibration, and pump failure.
Maintenance and Inspection
• Regular maintenance and inspections are a necessity for continued
efficient functioning. If any abnormal conditions are noticed, refer to the
section on Troubleshooting and take corrective measures immediately.
Monthly Inspection
• Check for any drop in performance. Reduced performance is usually
caused by debris blocking the pump intake.
• Detach the power cable from the receptacle or turn off the power
supply (circuit breaker).
• Disconnect the pump discharge and remove the pump from the water.
• Remove any accumulated debris from the surface of the pump, inlet
and impeller.
• Do not disassemble the pump for any reason. Disassembly will void
the pump warranty. Refer operating and maintenance problems to a
qualified technician.
5