Epson DS500 - Manual (Page 13)

English
11
Go online to www.dewalt.com/mobilelock or call the phone menu
system (1-410-329-9477) to perform a system test.
TO COMPLETE THE SYSTEM TEST THROUGH THE WEBSITE
1. Go online to www.dewalt.com/mobilelock and enter login and
password.
2. Select Unit Customization .
3. Select unit.
4. Select
System Test. The MOBILELOCK TM unit will cycle through
all the ACTIVE sensors in the following order: vibration, door
contact, motion, and tamper. As you trip each sensor, the
MOBILELOCK
TM unit will sound an alarm. A cellular notification
will not be sent. Continue tripping sensors until the test is
complete. The test will automatically time out after 5 minutes or
when each of the sensors has been tripped.
TO COMPLETE THE SYSTEM TEST THROUGH THE
PHONE MENU
1. Call 1-410-329-9477 and enter login and password.
2. Select
Unit Maintenance from the main menu.
3. Select Status Update followed by System Test.
4. Status will offer the following information:
• Armed/disarmed/scheduled
• Battery level
• Cellular signal strength
• Sensor settings
• Alarm siren setting
5. Select Perform a System Test . The MOBILELOCK TM unit will
cycle through all the ACTIVE sensors in the following order:
vibration, door contact, motion, and tamper. As you trip each
sensor, the MOBILELOCK
TM unit will sound an alarm. A cellular
notification will not be sent. Continue tripping sensors until the
test is complete. The test will automatically time out after
5 minutes or when each of the sensors has been tripped.
DS510 INDOOR MOTION DETECTOR COVERAGE TEST
While the system is unarmed, performing this test which will
indicate the coverage area without sending an alarm. Hold the
enclosed magnet on the bottom left side of the motion detector
(near lens) until a red LED is shown in the window. This activates
the 1 minute test mode. Within this period, a red LED will light every
time the unit senses motion.
Arming
The MOBILELOCK TM unit can be armed via the phone menu
system or the MOBILELOCK TM website. For added convenience an
arming and disarming schedule can be set.
NOTE: The MOBILELOCK
TM website and phone menu is subject
to change.
ARM VIA PHONE
1. Call 1-410-329-9477 and enter login and password.
2. Select
Arm/Disarm menu from the main menu.
3. If you have more than one MOBILELOCK TM unit, you will be
asked to select the correct one, select a group, or select all.
4. Select Arm .
5. Wait for the phone menu to provide confirmation that the unit
has been armed. Do not hang up before this confirmation.
NOTE: If you have chosen to activate the arm and disarm confir-
mation chirps, the MOBILELOCK
TM unit will beep to indicate the unit
is armed.
ARM VIA MOBILELOCK TM WEBSITE
1. Go online to www.dewalt.com/mobilelock and enter login and
password.
2. Select Unit Customization.
BASIC OPERATIONS
DS500 E,Sp 8/9/06 11:04 AM Page 11