Eneo PXD-1080MIR D - Manual (Page 8)

8
CAUTION:
Extreme care should be taken NOT to scratch the bubble dome
surface while the camera installing or adjusting.
Extreme care should be taken NOT to apply force to IR LEDs.
Care should be taken the cable is NOT to be damaged, kinked or
exposed in the hazardous area.
Do not expose the camera directly to a strong light source such
as the sun or spot light.
Power supply connections
Make sure the power is removed before the installation. Camera can work with either
12VDC or PoE (IEEE Std. 802.3af). Primary and secondary grounds are completely isolated
to avoid the possible ground loop problems.
1. Plug the network cable into RJ-45 Ethernet Port. If PoE is the unique power, there
will be no need to connect Power terminal.
2. When DC12V Local power is necessary, connect the low voltage (DC12V) first,
then plug the DC adapter to DC outlets to avoid an improper reset from power
jitter and a damage from the surge voltage when no load.
i When PoE and local power are connected at the same time, local power has priority.
Network Connection and IP assignment
eneo Scan Device Tool
The eneo Scan Device Tool is used to locate all eneo network cameras in a local network.
The tool does not need to be installed with a setup program. The program exe-file can be
started directly from the CD with a simple double click to use the program.