H3C Technologies H3C S7500E Series Switches - Manual (Page 22)

19
Figure 23 Connecting the console port to a PC
Setting terminal parameters
To configure and manage the switch through the console port, you must run a terminal emulator program,
HyperTerminal or PuTTY, on your configuration terminal. You can use the emulator program to connect a
network device, a Telnet site, or an SSH site. For more information about the terminal emulator programs,
see the user guides for these programs.
The following are the required terminal settings:
• Bits per second—9,600.
• Data bits—8.
• Stop bits—1.
• Parity—None.
• Flow control—None.
Powering on the switch
1. Make sure the power cords are connected correctly to the power source, and the power source is
supplying power correctly.
2. Turn on the circuit breakers for the power modules.
3. Power on the switch.
4. Verify that the LEDs on the switch are in the states as described Table 5 . For more information
about the LEDs, see H3C S7500E Switch Series Installation Guide.