H3C Technologies H3C S7500E Series Switches - Manual (Page 26)

16
Figure 9 Installing cage nuts (S7503E)
(1) Cage nuts
NOTE:
When preparing for installation, make sure the total height of the switches to be installed is not higher than
the height of the rack.
Installing accessories to the chassis
Installing mounting brackets and cable management brackets
Before installing the switch in the rack, install the mounting brackets and cable management brackets
shipped with the switch. Mounting brackets are used for attaching the chassis to the rack, and cable
management brackets are used for cabling the switch.
• S7506E-V—Install the mounting brackets and cable management brackets separately to the chassis.
For more information, see "
Installing the cable management brackets on the S7506E-V " and
" Installing the mounting brackets ."
1
1
1
1