Installing a fan tray, Figure 2-3, Figure 2-4 – H3C Technologies H3C S5800 Series Switches User Manual
Page 12
Advertising

2-3
Figure 2-3 Remove an LSW1FAN (2)
Figure 2-4 Remove an LSW1BFAN (2)
After removing a fan tray, place it in an antistatic bag.
Installing a fan tray
1) Put on an ESD-preventive wrist strap, make sure that the wrist strap has a good skin contact and is
well grounded.
2) Take out the fan tray from the package, and make sure that the fan tray model matches the device
model.
3) Holding the handle of the fan tray with one hand and its bottom with the other hand, gently insert
the fan tray into the fan tray slot until the fan tray connector well touches the backplane, as shown
in
Figure 2-5 Install an LSW1FAN (1)
Advertising
This manual is related to the following products: