H3C Technologies H3C S5560 Series Switches - Manual (Page 6)

6
Removing an interface card
CAUTION:
• Before you remove an interface card, remove the cable from it.
• After removing an interface card, if no new interface card is to be
installed, install the filler panel as soon as possible to prevent dust
and ensure good ventilation in the device.
To remove an interface card:
1. Prepare an anti-static bag.
2. Use the Phillips screwdriver to loosen the captive screw on the
interface card, as shown by callout 1 in
Figure 4 .
3. Rotate outward the ejector lever as shown by callout 2 in Figure 4 .
4. Pull out the interface card slowly out the interface card slot as shown
by callout 3 in Figure 4 .
5. Place the removed interface card in the anti-static bag.
Figure 4 Removing an LSWM2QP2P interface card
Installing and removing QSFP+ transceiver modules or
DAC cables
For information about installing or removing QSFP+ transceiver modules
or DAC cables, see H3C QSFP+ Transceiver Modules[Cables]
Installation Guide
at www.h3c.com.
2
3
1