Defining a class – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 26
17
Figure 4 QoS policy configuration procedure
Defining a class
To define a class, specify its name and then configure the match criteria in class view.
To define a class:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a class and enter class
view.
traffic classifier tcl-name [ operator
{ and | or } ]
By default, the operator of a class
is AND.
The operator of a class can be
AND or OR.
•
AND—A packet is assigned to
a class only when the packet
matches all the criteria in the
class.
•
OR—A packet is assigned to a
class if it matches any of the
criteria in the class.
3.
Configure match criteria.
if-match match-criteria
For more information, see the
if-match command in ACL and
QoS Command Reference.
Define a class
Define a behavior
Define a policy
Apply the policy
Apply the
policy to an
interface
Apply the
policy to
online
users
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points