Anycast rp configuration, Network requirements – H3C Technologies H3C SecPath F1000-E User Manual
Page 85
24
Anycast RP Configuration
Network requirements
•
As shown in
, the PIM-SM domain in this example has multiple multicast sources and
receivers. OSPF runs within the domain to provide unicast routes.
•
It is required to configure the anycast RP application so that the receiver-side DRs and the
source-side DRs can initiate a Join message to their respective RPs that are the topologically nearest
to them.
•
On Device B and Device D, configure the interface Loopback 10 as a C-BSR, and Loopback 20 as
a C-RP.
•
The router ID of Device B is 1.1.1.1, while the router ID of Device D is 2.2.2.2. Set up an MSDP
peering relationship between Device B and Device D.
Figure 7 Network diagram for anycast RP application configuration
Loop
0
Loop2
0
Loop
20
Loop0
G
E
3
/0
G
E
3
/0
G
E
3
/1
G
E
3
/0
G
E
2
/0
G
E
2
/0
G
E
2
/0
G
E
2
/0
Device
Interface
IP address
Device
Interface
IP address
Source 1
—
10.110.5.100/24
Device C
GE3/0
192.168.1.2/24
Source 2
—
10.110.6.100/24
GE3/1
192.168.2.2/24
Device A
GE1/1
10.110.5.1/24
Device D
GE1/1
10.110.3.1/24
GE2/0
10.110.2.2/24
GE2/0
10.110.4.1/24
Device B
GE1/1
10.110.1.1/24
GE3/0
192.168.2.1/24
GE2/0
10.110.2.1/24
Loop0
2.2.2.2/32
GE3/0
192.168.1.1/24
Loop10
4.4.4.4/32
Loop0
1.1.1.1/32
Loop20
10.1.1.1/32
Loop10
3.3.3.3/32
Device
E
GE1/1
10.110.6.1/24
Loop20
10.1.1.1/32
GE2/0
10.110.4.2/24