H3C Technologies H3C SecBlade FW Cards - Manual (Page 16)

5
Use the undo port inline-interfaces command to remove the interface from the inline forwarding entry.
Note that:
• A forward-type inline forwarding entry must contain two interfaces; otherwise, it does not take
effect. If only one interface is assigned, this interface performs general Layer 2 forwarding.
• A reflect-type or blackhole-type inline forwarding entry can contain only one interface.
Examples
# Assign Ten-GigabitEthernet0/0.1 and Ten-GigabitEthernet0/0.2 to forward-type inline forwarding
entry 2.
<Sysname> system-view
[Sysname] inline-interfaces 2
[Sysname] interface ten-gigabitethernet 0/0.1
[Sysname-Ten-GigabitEthernet0/0.1] port inline-interfaces 2
[Sysname-Ten-GigabitEthernet0/0.1] interface Ten-GigabitEthernet0/0.2
[Sysname-Ten-GigabitEthernet0/0.2] port inline-interfaces 2