Configuration procedure – H3C Technologies H3C SecBlade FW Cards User Manual
Page 6
5
Figure 5 Network diagram
Configuration procedure
By default, the system has created the Trust, DMZ and Untrust zones, and you only need to deploy them.
1.
Deploy the Trust zone:
Add interface Ten-GigabitEthernet 0/0.1 to the Trust zone.
a.
Select Device Management > Zone in the navigation tree.
b.
Click the
icon of the Trust zone.
c.
Select Ten-GigabitEthernet 0/0.1.
d.
Click Apply.
2.
Deploy the DMZ zone:
Add interface Ten-GigabitEthernet 0/0.2 to the DMZ zone.
a.
Select Device Management > Zone in the navigation tree.
b.
Click the
icon of the DMZ zone.
c.
Select Ten-GigabitEthernet 0/0.2.
d.
Click Apply.
3.
Deploy the Untrust zone:
Add interface Ten-GigabitEthernet 0/0.3 to the Untrust zone.
a.
Select Device Management > Zone in the navigation tree.
b.
Click the
icon of the Untrust zone.
c.
Select Ten-GigabitEthernet 0/0.3.
d.
Click Apply.