H3C Technologies H3C Intelligent Management Center - Manual (Page 78)

69
Software version used
This configuration example was created and verified on the following platforms:
• IMC PLAT 7.1 (E0301)
• IMC UBA 7.1 (E0301)
• H3C S7503E, Comware Software Version 5.20 Release 6708P08
• H3C SecBlade NetStream card, Comware Software Version 5.20 Release 3109P03
Configuring NetStream on the S7503E switch
1. Configure the S7503E switch:
# Create local mirroring group 1.
[Sysname] system-view
[Sysname] mirroring-group 1 local
# Configure mirroring group 1 to monitor the incoming and outgoing traffic on GigabitEthernet
2/0/2.
[Sysname] mirroring-group 1 mirroring-port GigabitEthernet2/0/2 both
# Configure Ten-GigabitEthernet 2/0/1 as the monitor port of mirroring group 1.
[Sysname] mirroring-group 1 monitor-port Ten-GigabitEthernet2/0/1
# Enable ACSEI server so that the NetStream card can synchronize the clock of the MPU on the
switch.
[Sysname] acsei server enable
2. Configure the NetStream card:
# Create blackhole-type inline forwarding entry 1.
[Sysname] inline-interfaces 1 blackhole
# Assign Ten-GigabitEthernet 0/1 to inline forwarding entry 1.
[Sysname] interface Ten-GigabitEthernet0/1
[Sysname-Ten-GigabitEthernet0/1] port inline-interfaces 1
# Enable NetStream for incoming traffic on Ten-GigabitEthernet 0/1.
[Sysname-Ten-GigabitEthernet0/1] ip netstream inbound
# Enable ACSEI client on Ten-GigabitEthernet 0/1 so that the NetStream card can synchronize
the clock of the MPU on the switch.
[Sysname-Ten-GigabitEthernet0/1] acsei-client enable
[Sysname-Ten-GigabitEthernet0/1] quit
# Specify the export destination host as 192.168.1.220 with UDP port 9020.
[Sysname] ip netstream export host 192.168.1.220 9020
# Configure the switch to export NetStream data in the version 9 format. The NetStream
traditional data export uses the version 5 format by default.
[Sysname] ip netstream export version 9