Grass Valley 2000NET v3.1 - Manual (Page 35)

2000NET Instruction Manual 35
2000NET Module Interface
Network Configuration Changes
After initial frame network addressing is done using the RS-232 port, sub-
sequent address changes may be made using the menu on the 2000NET
Network page illustrated in
Figure 24 .
The 2000NET module must be rebooted before changes will take effect. You
can reboot the module from the Network page by clicking the
Reboot
button. The Reboot button can also be found on the Configuration page.
Figure 24. Configuring the 2000 Network
Note SubNet Mask and Gateway IP Address are required.
Use
This
Link
Frame
Machine
Address
Enter and Apply
Network
Parameters