Grass Valley 8943CF User Manual
Page 16
16
8943CF — Instruction Manual
Installation
3.
The finished installation should look like the example in
. The
label will list the GV Model number, the GV part number, and the
manufacturer’s part number. Also note the two arrows on the label will
indicate signal direction as shown in the dual transmitter example in
(arrows pointing out). A dual receiver will have two arrows
pointing in, and a transceiver will have one input and one output
arrow.
Figure 6. Finished Bracket Mounting
Once you have put the mounting brackets onto the two SFP devices, install
them on the top (component) side of the circuit board and cable them to the
LC adapter output connectors on the main module with the fiber cable
assemblies provided.
shows an empty circuit board and the connector locations (J4 and
J6) where the SFP devices will be installed.
Figure 7. Example of a Complete SFP Installation
Fiber cable connectors
SCA-2 (electrical) connector
Arrows indicating SFP device type
J4 - F3/F4
J6 - F1/F2