Epic Fitness 425 MX EPTL88105.0 - Manual (Page 8)

8
4
5
48
5. Attach the Catch (5) to the left side of the Frame (48) with
two 3/4” Screws (4).
With the help of a second person, raise the Frame (48) to
a vertical position.
Be careful not to raise the Frame
past the vertical position. Have the other person hold
the Frame until step 7 is completed.
5
6. Hold the cylinder end of the Shock (88) near the bracket
in the center of the Belly Pan (50).
See the two small inset drawings. Using your fingernail
or the end of a screwdriver, press on the end of the
Shock Pin (102) to loosen it from the Shock (88). Next,
rotate the Shock Pin and pull it out of the Shock.
Be
careful to avoid losing the Shock Pin.
Orient the Shock (88) so it is in the position shown. Press
the end of the Shock onto the ball on the bracket.
See drawing 6a. Insert the Shock Pin (102) into the two
indicated small holes in the end of the Shock (88). Then,
rotate the Shock Pin until it clips onto the Shock. Note:
Extra Shock Pins are included.
102
50
88
Hole
Hole
102
88
6
6a
Bracket
Cylinder
Bracket
7. Remove the Shock Pin (102) from the lower end of the
Shock (88).
Next, press the lower end of the Shock (88) onto the ball
on the bracket on the Base (83). If necessary, pivot the
Frame (48) slighty and rotate the Shock to align the end
of the Shock with the ball on the bracket.
See drawing 7a. Insert the end of the Shock Pin (102)
into two of the small holes in the end of the Shock (88).
Then, rotate the Shock Pin until it clips onto the Shock.
With the help of a second person, lower the Frame (48)
to the floor.
88
102
88
102
7
83
48
Bracket
Bracket
102
102
7a