Grass Valley 8900-FRMKIT User Manual
Page 4
4
8900-FRMKIT — Installation Instructions
CAUTION The screws used for installing this rack mount kit must not exceed 1/4”or
6.35 mm in length. If you have ordered the Field Mod Note to drill holes in the
frame, use the only the self-tapping screws provided in the FMN kit to attach
the side supports.
6.
Once the side supports are installed, re-install the frame into the front
of the rack with the side supports on the inside of the rack rear.
7.
From the back of the rack, slide the rear brackets provided over the ends
of the attached rack supports as shown in
8.
Line up the holes in the rear brackets with holes in the rack and attach
the rear brackets to your rack with rack screws and any other mounting
hardware required (not provided) depending on your rack type.
This completes the installation.
Figure 2. Install Rear Brackets to Rack
Rack screws and other
required mounting
hardware not supplied
Rear Brackets
Finished installation
8499_01
r1