Grass Valley K2 Edge User Manual v.4.0 - Manual (Page 10)

K2 Edge User Manual - document version: 4.0 – Page 10
8.4 System configuration
8.4.1 Network configuration
• Hostname: the K2 Edge hostname.
Click Set to save changes.
• IP-manager: specify network settings for the IP Manager. Note that the IP Manager has its own
IP-address.
• Use DHCP: On/Off
• IP-address
• Netmask
• Gateway
• Nameserver
Click Set to save changes.
• K2Edge: specify network settings for the K2 Edge server.
• Network port 0-3
 Method: Auto, using DHCP/Manual or Manual
 IP-Address
 Netmask
 The system’s MAC address is displayed.
Click Set to save changes.
• Gateway
• Nameserver
Click Set to save changes.
• TX/MAM server virtual IP: the TX/MAM servers’ virtual IP-address.
Click Set to save changes.
8.4.2 Channel configuration
•
Video Bypass: enable (activate) or disable the bypass.
• Channel layout: select one of the following presets:
• 1xSD (1) : single SD (with preset 1)
• 1xSD (2) : single SD (with preset 2)
• 1xHD (1) : single HD (with preset 1)
• 1xHD (2) : single HD (with preset 2)
• 1xSD+preview (1) : single SD + preview (preset 1)
• 1xSD+preview (2) : single SD + preview (preset 2)
• 1xHD+preview (1) : single HD + preview (preset 1)
• 1xHD+preview (2) : single HD + preview (preset 2)
• Simulcast
• Custom setup
• Region: select PAL or NTSC
• Genlock: select Blackburst or Trilevel sync