Grass Valley K2 Dyno Quick Start v.1.6 - Manual (Page 7)

13 April 2010 K2 Dyno Replay System Quick Start Guide 7
Cable K2 Summit Client
Cable K2 Summit Client
If desired, mount the K2 Summit Client in an equipment rack. Refer to the K2 System
Guide for rack mount procedures.
Make K2 Summit Client cable connections as illustrated.
Each channel can be both an input (record channel) and an output (play channel). For
the K2 Dyno Replay System documented in this Quick Start Guide, C1 and C2 are
record channels and C3 and C4 are play channels.
For complete cabling instructions, refer to the K2 System Guide. If using ChannelFlex
Suite™ features, refer to the K2 Dyno Controller Installation Manual and the K2
AppCenter User Manual.
Cable K2 Dyno Controller
Make K2 Dyno Controller cable connections as illustrated.
The Ethernet connection between the K2 Summit Client and the K2 Dyno Controller
can be via direct connect cable or via an Ethernet switch.
C1 C2 C3 C4
!
OK
~AC
!
OK
~AC
SDI IN1 SDI OUT1 SDI OUT2 LTC I/O
AES AUDIO RS422
SDI OUT1 SDI OUT2
USB/1394 100BT/1000BT
GPI
VGA REF. LOOP THROUGH
AES AUDIO RS422
LTC I/O SDI IN2 SDI IN3 SDI IN1 SDI IN2 SDI IN3 SDI IN1 SDI OUT1 SDI OUT2 LTC I/O
AES AUDIO RS422
SDI OUT1 SDI OUT2
AES AUDIO RS422
LTC I/O SDI IN2 SDI IN3 SDI IN1 SDI IN2 SDI IN3
Power
cord Power
cord
AES
audio
Keyboard
and mouse VGA
monitor
Channels (C1, C2, C3, C4) are bi-directional
Ethernet
Use C1 as
record channel.
Connect SDI in Use C2 as
record channel.
Connect SDI in Use C3 as
play channel.
Connect SDI out Use C4 as
play channel.
Connect SDI out
100-240 V~
4A 50-60Hz
RS-232
Power
cord
Keyboard
and mouse
VGA
monitor Ethernet