Grass Valley K2 InSync v.4.0 - Manual (Page 19)

August 4, 2008 K2 InSync User Guide 19
Changing the slave K2 to be master
1. Install K2 InSync on K2 B (if it is not already installed). Follow the installation
instructions given earlier.
2. On K2 B, set K2 B as master and K2 C as slave.
3. Select Manual synchronization mode so that you can control the start of the
synchronization.
4. Make other configurations, according to your synchronization requirements.
5. Click OK .
6. If you do not want to use the configuration file immediately, save it with an
appropriate name, then re-load your previous configuration.
7. If you do want to use the configuration immediately, first make sure that PortServer
is running on K2 C, then click the Start button.
8. After the initial synchronization completes, you can change the synchronization
mode according to your ongoing synchronization requirements.