Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 131)

June 25, 2009 K2 Media Client Service Manual 131
SATA drive connector board removal
SATA drive connector board removal
The procedure applies to SAN client systems that have SATA drive connector boards
rather than a SCSI backplane. To remove a SATA drive connector board, first remove
the top cover and the codec board, then proceed as illustrated.
When re-connecting SATA cables for installation, note that cables connect to the top
SATA connector only.
Procedure continues on next page.
Remove
RTP board 2
Disengage
all RAID
drives 1
Disengage
rear card
guide and
lay it back 4
Disconnect
DVD drive
cables 3
Remove
rear card
guide 6
Remove
power and
SATA cables
from drive
connector board 5