Elmo Vandal Resistant Dome Camera TND4204VX - Manual (Page 8)

Base pan
Lens
(Fig.7)
Camera mounting bracket
BNC
cable
Power cord
Main body
7
5. Connect the power cord and the BNC
cable, and then mount the main body on
the camera body. (Fig. 6).
· When you connect the Power cord and
the BNC cable, roll the waterproof tape
to prevent water damage as the figures
below indicate.
6. While watching the monitor, adjust the
image direction.
· Right/left direction (Fig.7)
Rotate the base pan to right or left, and
adjust the right/left direction.
· Up/down direction (Fig.8)
Loosen the tilt lock screw, and adjust
up/down direction.
After setting the up/down direction,
fasten the tilt lock screw.
(Fig.6)
W a r n i n g
Weight of the camera mounting
bracket and mounting metal
piece is 1600g(3.52 lbs).
Make sure that the ceiling or wall
is strong enough to support the
weight of the camera mounting
bracket and mounting metal
piece altogether.If not strong
enough, the device may drop
and injure the personnel around.
C a u t i o n
Please do not hold a part of the
lens, when adjusting the image
direction. It may cause a
breakdown of the lens.
Power cord
BNC cable