Grass Valley Krystal Multi-Channel User Manual
Page 5
Krystal Multi-Channel Upgrade
3
b.
The Large System Controller frame has slots for up to four Effect
Managers and four Effect Manager I/O Modules. Install at least one
Effect Manager (#066224-00S or later) and one Effect Manager I/O
module. Effect Manager CPU modules are inserted into the labeled
slots in the front bay of the Large System Controller, starting at the
slot labeled 1 (actually slot #12 counting from the left) with
subsequent modules inserted toward the left (slots labeled 2, 3, and
4). If only one Effect Manager is being installed it must be in the slot
labeled 1 (#12). The Effect Manager I/O modules go into slots at the
rear of the frame that correspond to the Effect Manager CPU
modules installed in the front (rear labeled slots 1, 2, 3, 4).
Note
Each Effect Manager in the Large System Controller frame that will be used for
combining will need a 4 Channel Combiner Output module installed in the num-
bered slot that corresponds to that Effect Manager.
4.
Observing anti-static precautions, remove the single channel Video
Processor I/O module (#066226) in the back of each Video Processor
frame being upgraded and replace it with the multi-channel Video
Processor I/O module (#066237) included in the upgrade kit.
5.
Set the hardware IDs of all the Video Processor frames in your system.
The hardware ID is set using a screwdriver dial adjustment located on
the right side of the switch (
Figure 1
). You may need to remove the
module from the frame to reach this switch. Each Video Processor CPU
must have a different hardware ID. Setting 0 corresponds to the Video
Processor module in the frame identified as Channel 1 in the Physical
Channel Configuration menu (
System Setup
\
SYSTEM CONFIG>
\
CHANNEL CONFIG>
), Setting 1 corresponds to the Video Processor CPU
module in the frame identified as Channel 2, and likewise for the
remaining channel assignments. The settings must be correct for the
system to work properly.
6.
Connect your Video Processor video and control wiring as required for
your facility. Refer to the Krystal Installation and Service Manual for
detailed information.