Grass Valley PLS20 - Manual (Page 16)

6 Profile PLS20 Data Tape Drive
Connect Power
To connect power to the tape drive:
1. Connect the power cord to the back.
2. Press the power switch to the on ( l ) position.
Be sure to power on the PLS20 before starting the Profile system to
ensure that the Profile Data Tape Drive is recognized as a SCSI
device.
The tape drive performs its power-on self-test in about 30 seconds. When the
tape drive is ready to accept a cartridge, the LEDs turn off.
➤ Important: Do not insert a cartridge into the tape drive during the
power-on self-test. The tape drive will eject the cartridge.