Removing the chassis cover – Grass Valley PAC 216 Upgrade User Manual

Page 12

Advertising

PAC 216 Upgrade Installation

Removing the Chassis Cover

To remove the chassis cover, refer to Figure 1 and:

1. Turn PAC200 power off and remove the power cord.

2. Use the Torx tool with the T15 tip to remove the four screws from the chassis

cover: two on top and two in the rear, as shown in Figure 1.

NOTE: Take care not to lose these chassis screws. They are required to meet
the EMI specifications for the PAC 208.

3. Lift the cover from the chassis and set aside.

Advertising