Polaris 2001 ATV Universal ATV - Manual (Page 105)

94
BATTERY
1. Set the battery in its holder.
2. Install the battery vent tube. It must be free from obstructions
and securely installed. If not, battery gases could accumulate
and cause an explosion. The tube should be routed away from
the frame and body to prevent corrosion. Avoid skin contact
with electrolyte, severe burns could result.
3. First connect and tighten the red (positive) cable.
4. Second connect and tighten the black (negative) cable.
5. Reinstall battery cover and attach the hold down strap.
6. Verify that cables are properly routed.
NOTE:
D
When your ATV is placed in storage for three months or
more, the battery should be removed, charged to proper level,
and stored in a cool dry place.
D Before reusing, take the battery to your dealer for testing
and recharging.
D Power plug leads may need to be bent down so that the bat-
tery cover may be installed.
D When installing a new battery, make certain it is fully
charged prior to it’s initial use. Using a new battery that has
not been fully charged can damage the battery resulting in a
shorter life of the battery. It can also hinder vehicle perfor-
mance.