Ericsson A1228c - Manual (Page 12)

Not for Commercial Use - Ericsson Inc.
6 Getting Started
charging the battery. When your phone is fully charged, the plug
icon will remain stable.
Note! You cannot make or receive calls when your phone is in charge-only
mode.
Slow Charging a Deeply Discharged Battery
The battery could become deeply discharged (for example, when the
battery is stored for a long period). As a result, the phone may not
immediately activate charge-only mode when the charger is con-
nected.
à Attach the charger to the phone for several hours to slowly charge
(trickle charge) the battery.
!Ã After trickle charging the battery for several hours the phone
should activate the charge-only mode automatically.
"Ã Continue charging the phone until the battery is fully charged.
Turning Your Phone On and Off
Turn your phone On by pressing and holding N O until your phone
turns on. The phone will beep (unless silent mode is activated). Turn
your phone Off by pressing and holding
N O until your phone turns
off. You must return to Standby mode to turn off your phone.
Making and Receiving Calls
See “Voice Calls” on page 17 for more information about making
and receiving calls.
Making Calls
à Press the numeric keys to enter the phone number you want to
call. The number is shown in the display.
Note! You can press B A CK to erase one or more digits in the display, or
press and hold B A CK to erase all digits.
!Ã Press
Y E S . 8hyyvt, along with the number you are dialing, is
shown in the display while your phone accesses the wireless net-
work.
"Ã When the call is connected, a call timer is shown in your display.
The phone number that you dialed will remain on your screen.
#Ã To end the call, press
N O .
Receiving Calls
When your phone receives a call, the ringer sounds, Dp‚€vtÃ8hyy
appears in the display, and the display and keypad backlight illumi-
nate. You can temporarily silence the ringer by pressing
N O or the
upper or lower side keys, and still answer the call by pressing Y E S . If
you have Caller Number Identification (Caller ID) service from your
service provider, the caller's phone number is shown in the display.
The caller’s name will also appear if the phone number is found in
your phonebook.
Answer the phone by pressing any key. For information on adjusting
your answering preferences, see “Auto Answer” on page 13.
Dp‚€
vtÃ8hyy is replaced by the call timer display once the call is
answered. End the call by pressing
N O .