Polaris 2004 Victory Vegas - Manual (Page 52)

50
PRE-OPERATION CHECK
Check Electrical Equipment
To perform a pre-operation check on the electrical equipment, set the ignition switch to the ON position. Set the
ignition switch to the OFF position after completing the electrical equipment portion of the pre-operation check.
Indicator Lights
The low oil pressure indicator should illuminate until the engine is started. If the transmission is in neutral, the
neutral indicator should remain illuminated.
Headlamp
Check the headlamp to see that it is on. Set the headlamp switch to the high beam position. The headlamp
brightness should increase and the headlamp high beam indicator light should illuminate.
Taillight / Brake Light
With the ignition switch in the ON position, the taillight and the license plate light should illuminate. Apply slight
pressure to the front brake lever; taillight brightness should increase. Apply slight pressure to the rear brake pedal;
taillight brightness should increase.