Polaris 2008 Victory Hammer - Manual (Page 93)

88
MAINTENANCE
Drive Belt
Check Drive Belt Tension
1. Place the transmission in Neutral and lift the rear wheel off the ground
with an appropriate motorcycle lift or a block of wood or steel placed
securely under the frame.
Care should be taken to be sure the motorcycle will not tip or fall while elevated. Severe personal injury
or death may occur if the motorcycle tips or falls.
WARNING
2. Position the small O-ring on the belt tension gauge directly over
the 10 lbs. mark on the plunger as shown.
3. Place a tape measure or rule next to the drive belt as shown.
1. Drive Belt
2. Belt Tension Gauge
3. Rule
1
2
3