Estate Swing E-SC 1600 - Manual (Page 8)

T
o
o
ls
N
e
e
d
e
d
Other items that may be needed prior to commencing installation.
•
Start and stop post, bracket or door stop. Although the Estate Swing E-SC 1602 features
soft start/stop and can be used with limit switches (not included), it is possible to use the
E-SC 1602 without limit switches, relying on the positive stops to determine end posi-
tions.
•
16, 14 or 12 gauge, 2 conductor stranded direct burial low voltage wire will be re-
quired to run power to your operator. Length is determined by distance between trans-
former power supply and the control box.
•
A voltage meter and digital camera may be necessary to run diagnostic checks.
•
4 - 3/8” Red Heads, Lag Screws and Shields, or another brand wall mounting 3/8”
bolt and anchor will be needed to connect the Base Plate to the wall.
•
2 - 5/16” Hex Bolts will be needed to connect the Door Mounting Bracket to the door.
Length will be determined by what is needed for a secure anchor.
•
If your transformer is going to be plugged into an outdoor outlet you will need to weather-
proof that outlet and transformer. Electrical boxes or plug covers can be obtained from a
local hardware store to accommodate both the plug and transformer.
•
Hardware to attach the control box to a wall.
•
Watertight connectors for running wires into the control box.
1.4
•
Power Drill and appro-
priately sized bits.
•
Crescent Wrench
•
Flat Head Screwdriver
•
Nuts, Bolts, Anchors
and Washers (see below)
•
C-Ring Pliers
•
Phillips Head Screw-
driver
•
Tape Measure
•
Level
•
Wire Strippers
•
C-clamps
•
Carpenters Clamps