Energizer 371 - Manual

Chemical System: Silver Oxide (Zn/Ag
2
O)
Designation: IEC-SR69
Nominal Voltage: 1.55 Volts
Typical Capacity: 34 mAh* (to 1.3 volts)
Capacity Test: 30K ohm continuous drain at 21°C
Typical Weight: 0.7 grams (0.023 oz.)
Typical Volume: 0.15 cubic centimeters (0.009 cubic inch)
Impedance (40 Hz): 5 to 15 ohms
Load Cutoff
1.3V
(ohm) (hours)
30K 665
Typical Performance at Low Discharge Rates
Temperature Characteristics
SILVER OXIDE
Specifications
Cross Section
* Varies according to the applied load, temperature, and cutoff voltage.
Industry Standard Dimensions
ENERGIZER 371/370
©Energizer Holdings, Inc. - Contents herein do not constitute a warranty.
Important Notice
This datasheet contains typical information specific to products manufactured at the time of its publication.
Continuous 0.052
at 1.55V
(milliamperes)
Schedule Typical Drains
Typical Performance at 21°C (70°F)
mm (inches)
Typical Discharge Characteristics
PRODUCT DATASHEET
1-800-383-7323 / USA
1-800-383-7323 / CANADA 1-800-383-7323 USA/CAN
www.energizer.com
Schedule: Continuous
Typical Drain @1.55V:
0052 milliamperes
Load: 30K ohm
1.0
1.1
1.2
1.3
1.4
1.5
1.6
1.7
0 200 400 600 800
Service, Hours
V
o
lt
a
g
e
, CCV
DESIGNED FOR USE ON CONTINUOUS LOW DRAIN
HIGH PULSE ON DEMAND
Service Effects
0
25
50
75
100
125
-20 0 20 40
Temperature (C)
Se
rv
ic
e
(%
)
Storage Effects
60
70
80
90
100
0 2 4 6 8 10 12
Storage Time (yrs)
Se
rv
ic
e
(%
)
40°C
20°C
0°C
Anode Cap
Gel Anode
Gasket
Can
Separator
Cathode
9.50 (0.374)
9.25 (0.364)
0.03 (0.001) Minimum Ref.
(applies to top edge of gasket or
edge of crimp, whichever is higher)
3.80 (0.150)
Minimum
1.85 (0.073)
2.10 (0.083)
1.95 (0.077) Ref.
1.70 (0.067) Ref.
0.25 (0.010) Maximum Ref.
Permissible deflection from a flat
Form No. EBC - 4360A Page 1 of 1