Echo PE-200 - Manual (Page 10)

10
A
SSEMBLY
DRIVE SHAFT / POWER HEAD
Tools Required: 8 x 10 mm Spanner Wrench
Parts Required: Power Head, Drive Shaft Assembly
1. Stand engine on a level surface.
2. Loosen the two bolts (A) at drive shaft end of engine.
3. Carefully fit drive shaft assembly to engine, making sure that
inner drive shaft engages into clutch mount.
NOTE
Rotate the drive shaft housing until edger housing is in line with the
engine.
4. Tighten bolts (A).
THROTTLE LINKAGE
1. Manually pivot throttle rotor (B) clockwise until rotor stops, and
hold in place.
2. Insert throttle cable (C) through adjustment fixture (D).
3. Align slot in carburetor pivot (E) with throttle cable. Large hole in
side of pivot must face away from adjustment fixture.
4. Place cable into slot, and squeeze trigger slowly to seat cable end in
large hole. Release throttle rotor and trigger.
A
B
C
D
E