ShoreLand'r Fishing User Manual
Page 26
Advertising
Front Keel Roller:
Mount the 8” keel roller assembly to the front crossmember
using two (2) 1/2” X 1-1/4” hex bolts, two (2) 1/2” pyramidal
lock washers, two (2) 1/2” flat washers and two (2) 1/2” hex
finish nuts. Refer to the parts drawing for placement.
Bunks:
Mount the right and left fishing series bunk brackets to the
rear crossmember (in a location that would best fits your
water craft) using 3/8” X 3-7/16” X 2-1/2” square u-bolts, 3/8”
medium lock washers and 3/8” hex finish nuts. Mount the
bunk to the fishing series bunk brackets using 3/8” X 1” hex
bolts and 3/8” flange lock nuts. NOTE: Do not over tighten -
bunks must be able to pivot from side to side so that the hull
of the water craft will conform to the bunks.
Advertising
This manual is related to the following products: