Euro-Pro EP485 - Manual (Page 13)

13
TO EMPTY THE IRON
• Always empty iron after each usage.
• After using the iron, turn the variable steam control to ‘0’ and the temperature control dial to ‘minimum’.
• Unplug the iron from the power source.
• Set variable steam control to ‘MAX’.
• Open the water inlet cover and turn the iron up-side down over the sink with the tip pointing downward and
allow the water to flow from the opening.
• Set variable steam control to ‘0’.
• Allow iron to cool on the iron rest before storing.
WARNING: Use caution when you turn the iron up-side down - there may be hot water in the
reservoir. Burns can occur from touching hot metal parts, hot water or steam.
ELECTRONIC AUTOMATIC SHUT-OFF
Your EURO-PRO 2-in-1 Cordless/Corded Iron is equipped with an electronic auto shut-off. The electronic
auto-off switches the iron off if it has been standing unmoved for approximately 8 minutes. A red light will
flash when the iron switches itself off. To switch the iron back on again,shake the iron.
CAUTION: Do not use the auto shut-off feature as a substitute for turning the iron off and
unplugging the iron when not in use.
Red light will flash
when iron switches
itself off