ShoreLand'r SLV22LW V.2 - Manual (Page 8)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003701
Page 8 11/06/06
SPRINGS
Positions the axle so that it is aligned with the trailer.
Place the springs on the top side of the spring pads welded to
the axle. The hook end of the spring must be mounted to the rear
of the trailer. Place a spring clamp on the top center of the spring.
Place the 1/2” X 6-1/2” U-bolts over the top of the spring clamp,
spring and axle. Place the spring and axle U-bolt plate onto the
ends of the two U-bolts. Secure in place with 1/2” lock nuts. Tighten.
AxLE
Place a spring bracket bushing (Ref.#6) into the rear of the spring
bracket and secure with a 9/16” x 3-1/4” hex bolt and hex lock nut.
Repeat in the other spring bracket. Position the axle under the frame,
hook the hook loop of the spring around the bushings just installed.
Note: If the axle is positioned too low, the hooks will not hook around the
bushings.
Raise the front of the springs up so they align with the front hole of
the spring bracket. Secure in place with 9/16” X 3-1/4” hex bolts and
lock nuts. Tighten all axle U-bolts and spring bolts.
TIRE & WHEEL ASSEMBLY
Mount the tire and wheel assemblies using the 1/2” fine threaded ta-
pered lug nuts provided. Tighten to 85-95 ft./lb. of torque using the ro-
tation pattern as shown in the ShoreLandr’s Owners Manual.
Re-torque the lug nuts after 50 miles of driving and then
periodically thereafter.
Tire Size and Carrying Capacity Chart
Tire Size ............................ST185/80R 13-C
GVWR ...............................2200 lb.
Carrying Capacity ............1480 lb.
Axle ...................................Non-Brake
Refer to the tire side wall for correct tire pressure.
NOTE: Brakes available as optional equipment.
Recommended carrying capacity is based on shipping weight
of the trailer with standard equipment. Adding optional equip-
ment may decrease the trailer’s carrying capacity.