Electrolux EHD90LLUM - Manual (Page 24)

Cutting the benchtop out
• The bench cutout needs to be sized by
using the supplied template.
• A cutting accuracy of 1.5mm either
side of the marked area needs to be
maintained.
Pull down clamps
• These are supplied in a parts bag
consisting of 4 clamps and 4 screws.
• The clamps should be pre-assembled
onto the 4 brackets before dropping the
unit into the cutout.
Rubber seal
• An oversized length of rubber seal is
supplied in the parts pack
• This should be pushed into the recess
on the underside of the frame. The join
should lie in the middle of one side.
• The seal will have to be cut to length
(add a few mm) and then the two ends
pushed up against one another.
20 installation instructions electrolux induction cooktop
Installation instructions