ShoreLand'r LUB14TS - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004409
Page 4 07/28/2011
Diagram B
and insert a 3/8” x 4” hex bolt. Secure with a 3/8” flange lock nut.
Place a second 3/8” x 4” hex bolt down through the hole in the rear
of the tongue and the front cross member. Place on a 3/8” flange
lock nut. Tighten.
Connect the tongue wire harness into the side frame harness of
the trailer by matching plugs. Attach the white ground wire of the
tongue harness to the frame using a No. 10 x 3/4” self-tapping
screw provided so that a good ground connection is made between
the frame of the trailer and the tow vehicle. Push all extra wires
used to make the connection back inside either the side frames of
the trailer or else into the tongue. Place a second rubber grommet
into the hole where the wires exit the tongue to protect them from
damage during normal use.