SMA SB 3000TL Quick Installation Guide - Manual (Page 5)

SB3-5TL-21-IS-xx-11 5
ENGLISH
SAFETY INFORMATION
DANGER TO LIFE DUE TO ELECTRIC SHOCK
When exposed to sunlight, the PV array generates dangerous DC voltage which is present in the DC conductors
and the live components of the inverter. Touching the DC conductors or the live components can lead to lethal
electric shocks. If you disconnect the DC connectors from the inverter under load, an electric arc may occur
leading to electric shock and burns.
This manual is intended only for electrically qualified persons, trained in the installation and commissioning of
electrical devices and installations and experienced in mounting and commissioning PV systems. You can find a
detailed operating manual at www.SMA-Solar.com.
• Work on the inverter must only be performed by electrically qualified persons.
• Do not touch the DC conductors or any other uninsulated conductors.
• Do not open the upper enclosure lid.
• Disconnect the inverter from all voltage sources before working on the inverter or the PV array:
* Electronic Solar Switch (ESS) = optional
Disconnection point for interruption of the input current
DANGER: Only after Step 4 is the inverter voltage-free.
INSTALLATION MANUAL ➡ Page 24
Perform the following actions in the specified order and observe all information.
You can find a detailed operating manual for installation, commissioning and configuration as well as a service
manual for troubleshooting at www.SMA-Solar.com.
EC DECLARATION OF CONFORMITY
within the meaning of the EC directives
• 2004/108/EC (electromagnetic compatibility, EMC)
• 2006/95/EC (Low voltage, LVD)
• 1999/5/EC (Radio and Telecommunications Terminal Equipment, R&TTE)
SMA Solar Technology AG confirms herewith that the inverters described in this document are
in compliance with the fundamental requirements and other relevant provisions of the above
mentioned directives. The complete EC Declaration of Conformity can be found at www.SMA-Solar.
com.