Electrolux 534074 - Manual (Page 14)

16
E INSTALLATION AND ASSEMBLY
E1 Customer responsibilities
The Customer must provide for the following:
- installation of an adequate electrical power supply
ahead of the machine, according to the equipment’s
technical specifications (Table 1 and C2 “Character-
istics of power supply”);
- the equipotential ground connection of the workplace
electrical system to the metal structure of the
machine by means of a copper cable of adequate
section (see position “Q” in par. E6.2 “Installation dia-
grams”);
- Adducting for the electrical connection between the
workplace electric panel and the equipment;
- the water supply and drain connections and other
connections as indicated in Table 1 and par. E6
“Plumbing connections”;
- arrangement of general workplace lighting to guaran-
tee at least 500 lx according to point 5.2.2 of EN
12464-1 or according to a value established by the
current regulations in the country of use.
E2 Characteristics of the site installation
The machine is designed for installation in professional
and not domestic-type kitchens. Water collection traps/
metal grates must be arranged in the floor at the
machine discharges (see par. E6.2 “Installation dia-
grams”), possibly replaceable with a single water trap
sized for a flow rate of at least 0.79 gal/s (3 l/s).
E3 Machine space limits
A suitable space must be left around the machine (for
operations, maintenance, etc.).
The passages enabling personnel to operate on the
machine must be at least 27.55’’ ( 70cm) wide, except at
the rear of the machine (see par. E6.2 “Installation dia-
grams”).
The size must be increased in case of use and/or trans-
fer of other equipment and/or means or if exit routes are
necessary inside the workplace.
E4 Positioning
Unless otherwise agreed, the machine is supplied in a
single unit.
The machine must be taken to the place of installation
and the packing base removed only when being
installed.
Arranging the machine:
• Position the machine in the required place.
• Adjust the equipment by turning the special adjusta-
ble feet and making sure it is perfectly level, both
lengthwise and crosswise.
Figure 7 Feet adjustment
• Wear protective gloves and unpack the machine.
• Carefully remove the protective film from the outer
panels without tearing it, to avoid leaving traces of
glue.
E5 Disposal of packing
All materials used for packing are environmentally com-
patible. They can be safely kept, and recycled or burnt in
a special waste incineration plant. Plastic parts subject
to possible recycling are marked as follows:
Parts in wood and cardboard can be disposed of
respecting the current regulations in the country of use.
E6 Plumbing connections
Install the machine water filling and drain pipes accord-
ing to the plumbing circuit and installation diagrams
given below.
IMPORTANT
Before servicing, disconnect the electrical service
and place a red tag at the disconnect switch to indi-
cate work is being done on that circuit.
polyethylene: outer wrapping, instruc-
tion booklet bag.
polypropylene: roof packing panels,
straps.
polystyrene
foam: corner protectors.
IMPORTANT!
Machine installation operations must only
be carried out by specialized Technicians
provided with all the appropriate personal
protection equipment (safety shoes,
gloves, glasses, overalls, etc.), tools, uten-
sils and ancillary means.
PE
PP
PS