Extron electronic HPA 1001-70V - Manual

www.extron.com
© 2008 Extron Electronics. All rights reserved.
Pricing and specifications may change without notice.
USA West
+1.714.491.1500 / +800.633.9876
+1.714.491.1517 FAX
USA East
+1.919.863.1794 / +800.633.9876
+1.919.863.1797 FAX
China
+86.21.3760.1568 / +400.883.1568
+86.21.3760.1566 FAX
Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Europe
+31.33.453.4040 / +800.3987.6673
+31.33.453.4050 FAX
Dubai
+971.4.2991800
+971.4.2991880 FAX
Asia
+65.6383.4400 / +800.7339.8766
+65.6383.4664 FAX
www.extron.com
© 2008 Extron Electronics. All rights reserved.
Pricing and specifications may change without notice.
USA West
+1.714.491.1500 / +800.633.9876
+1.714.491.1517 FAX
USA East
+1.919.863.1794 / +800.633.9876
+1.919.863.1797 FAX
China
+86.21.3760.1568 / +400.883.1568
+86.21.3760.1566 FAX
Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Europe
+31.33.453.4040 / +800.3987.6673
+31.33.453.4050 FAX
Dubai
+971.4.2991800
+971.4.2991880 FAX
Asia
+65.6383.4400 / +800.7339.8766
+65.6383.4664 FAX
Continued
P o w e r A m P l i f i e r s
HPA 502
100 Watt Two Channel Half Rack Power Amplifier
unique feAtures
• 50 watts rms per channel into 4 or 8 ohms
• Two channel output for stereo or dual zone applications
• Independent level control for each channel
HPA 1001-70V
70 Volt 100 Watt Mono Half Rack Power Amplifier
unique feAtures
• 100 watts rms output for 70 volt speaker systems
• Input summing — Actively sums incoming left and right channel signals for mono
amplification.
• High pass filter — This switch selectable filter rolls off frequencies below 80 Hz to
prevent saturation of speaker transformers.
common feAtures
• Inputs: Balanced or unbalanced stereo on a captive screw connector
• Speaker Outputs: Screw-lock, 5 mm captive screw connector
• Professional grade amplifier design:
- Less than 0.05% Total Harmonic Distortion plus Noise
- Better than 100 dB Signal-to-Noise
• ENERGY STAR ® qualified amplifier — The HPA 502 and HPA 1001-70V are energy
efficient products to help meet green building requirements for low power consumption
and reduced operating costs.
• Highly efficient Class D amplifier design — The HPA 502 and HPA 1001-70V
generate substantially less heat than conventional amplifier designs, making them
ideal for installation in equipment racks and lecterns with very limited ventilation. They
consume 8 watts when idle and less than 1 watt in standby mode.
• Extron Patented CDRS ™ - Class D Ripple Suppression — A patented, exclusive
technology from Extron that eliminates the high frequency switching ripple and EMI
emissions found in typical Class D amplifiers. CDRS enables Extron power amplifiers to
be situated near wireless A/V devices without RF interference.
• Convection cooled — The HPA 502 and HPA 1001-70V are convection cooled without
the need for fans, ensuring quiet, reliable operation.
• Plenum rated when used with optional Flexible Conduit Adapter Kit,
part # 70-228-02 — The HPA 502 and HPA 1001-70V meet UL 2043 for smoke
and heat release for installation within a plenum airspace above a drop ceiling.
Above-the-ceiling placement conceals the amplifier to prevent theft, and is convenient
for installing equipment when space inside the room is limited.
• Compact 1U, half rack width metal enclosure — With the capability to deliver
full-sized amplifier power in half the size of many conventional amplifiers, the HPA 502
and HPA 1001-70V reduce rack space requirements for many installations.
• Auto-standby with fast power-up — The HPA 502 and HPA 1001-70V automatically
enter into a standby mode after one hour of inactivity, dramatically reducing power
consumption. They quickly return to full power status upon signal detection.
• Rear panel detented level controls — Provide attenuation of input signals for setting
proper audio system gain staging. They are located on the rear panel to prevent users
from tampering with level adjustments.
• Multiple protection circuits — Activate during excessive clipping, thermal overload, or
DC faults to prevent damage to the amplifier and speakers.
• Remote standby port — Enables the HPA 502 and HPA 1001-70V to be remotely
powered down when not in use, reducing operating cost.
• Remote volume and mute control port — In basic installations without third-party
control systems, this port allows the HPA 502 and HPA 1001-70V to be remotely
controlled using the optional Extron VCM 100 Series volume and mute or VC 50
volume controllers.
• Screw-lock, 5 mm captive screw speaker connectors — Enables simple, secure
connections with 22 to 14 AWG speaker cables.
• Front and rear-mounted signal and protection indication LEDs — Provide
convenient indication of amplifier operation from both sides of an equipment rack.
• Internal international power supply — The 100-240VAC, 50/60 Hz, universal power
supply provides worldwide power compatibility.
model
Version descriPtion PArt #
HPA 502 100 Watt Two Channel Power Amplifier . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60-849-01
HPA 1001-70V 70 Volt 100 Watt Mono Power Amplifier . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60-850-01
oPtionAl Accessories model descriPtion PAGe PArt #
Flexible Conduit Adapter Kit Flexible Conduit Adapter Kit for PS 123 & HPA Series Amplifiers . . . . . . . . . . . . . . . . page 140 70-228-02
RSU 129 1U 9.5" Deep Universal Rack Shelf Kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 819 60-190-01
RSB 129 1U 9.5" Deep Basic Rack Shelf . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 820 60-604-01
SPK 18 cable-25' Pre-cut Speaker Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 735 26-627-25
VC 50 Volume Control Wall Plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 674 70-530-02
VCM 100 AAP Volume and Mute Controller - AAP Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 674 70-396-11
VCM 100 MAAP Volume and Mute Controller - MAAP Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 674 70-397-11
SI 26X Two-Way Open Back Ceiling Speakers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 653 42-067-03
SI 26CT Two-Way Ceiling Speakers with 8" Back Can and Transformer . . . . . . . . . . . . . . . . . . . page 652 42-070-03
SI 26W Two-Way In-Wall Speakers with 6.5" Woofer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 654 42-068-03
SI 26 Two-Way Surface Mount Speakers with 6.5" Woofer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 648 42-072-02
656