EdgeStar AP10001B - Manual (Page 16)

13
Using the Remote Control
The remote control can be used instead of the control panel to remotely
operate your portable air conditioner. The functions on the remote are the
same as on the control panel.
Installing the batteries
Up Button
Power Button
Fan Speed Button
Timer On Button
Sleep Button
Timer Off Button
Lock Button
LED Display Button
Mode Button
Swing Button
Reset Button
1) Remove the cover on the back of the remote control.
2) Insert the batteries with the (+) and (-) ends pointing in the
correct direction.
3) Slide the cover back on.
CAUTION: Use only AAA batteries. Remove the batteries if the remote control will not be used for one
month or longer. Do not attempt to recharge batteries not designed to be recharged. All batteries should be
replaced at the same time. Do not mix old and new batteries. Do not dispose of batteries in a fire as they
may explode.
Button Function
On/Off
Powers the unit on or off.
Mode Changes between auto, cool, dehumidify and fan modes.
Speed Sets the fan speed between low, medium, high, or auto.
Timer On Used to enable the On timer and set the timed hours.
Timer Off Used to enable the Off timer and set the timed hours.
Temp Up Increases the set temperature by 2 degree increments
Temp Down Decreases the set temperature by 2 degree increments
Swing *Not an option on this model
Economy Enables the Sleep mode
Reset Used to cancel all controller settings
Lock Used to lock all controller settings and prevent settings from
changing
LED Used to light the display
NOTES: Be careful not drop
the remote control. Do not
place the remote control in
a location exposed to direct
sunlight.