Laney LV200 - Manual (Page 11)

18
19
20
21
22
17
11
Always switch off and disconnect
power cord when not in use
11
12
13
14
15
16
Controls the overall level on the drive1 channel. Use in conjunction with .
The VScoop switch drastically cuts out any mid frequencies present in the drive2 sound giving you a
very modern, aggressive lead tone.
Switch in to activate the drive2 channel. When active, control the amount of distortion with and the
overall volume with . The centre of the switch will be lit when active.
Sets the level of gain on the drive2 channel. For optimum results the gain control should be used in
conjunction with the volume control . Setting low levels of gain with high levels of volume will result in
a nice crisp blue’sy lead tone. Setting the gain control to midway with a medium volume level will give you
a punchy hard rock lead tone and setting the gain to maximum and backing the volume off, gives you a full
on metal lead tone. Obviously the type of guitar you use will have an effect on the overall sound you hear.
Controls the overall level on the drive2 channel. Use in conjunction with .
Controls the amount of bass or bottom end present on the two drive channels.
Controls the amount of mid present on the two drive channels.
Controls the amount of treble present on the two drive channels.
The ‘VTS Tone Shaping’ Radically alters the EQ of the amplifier by cutting some of the lower mid tones
and carefully boosting certain bass and upper mid frequencies. It is a global setting and may be used on
any of the channels giving you lots of different sound possibilities.
Sets the amount of reverb applied to the clean channel
Sets the amount of reverb applied to drive1 and drive2 channels.
Main power switch for the unit. Note: One of the three channel led’s will always be lit when the amplifier
is switched on.
10
14
15
15
14