Laney, Lx65r, Operating instructions – Laney LX65R User Manual
Page 6
V
OLUME
B
ASS
M
ID
I
NPUT
T
REBLE
CD/L
INE
I
N
F
OOTSWITCH
P
OWER
0
1
D
RIVE
E
QUALISATION
LX65R
R
EVERB
T
REBLE
FX S
END
B
ASS
M
ID
C
RUNCH
V
OLUME
D
RIVE
XTS
C
LEAN
E
QUALISATION
FX R
ETURN
Controls the amount of mid present on the drive channel.
Controls the amount of treble present on the drive channel.
Controls the amount of reverb applied to the signal.
Fancy playing along with a backing track? Connect your CD/MP3 player here.
Connect a Laney FS2 footswitch here to enable remote switching for the channel and reverb/FX. Note: Drive channel must
be enabled for channel switching via footswitch to function.
Effects send socket allowing you to connect to an external FX controller. You can also use it as a line out socket if you wish
to connect to another amplifier/PA etc.
Connect the output from your effects controller here.
When ‘on’ indicates that power is connected to the unit and it is ready to go.
(Always switch off and disconnect the power cord when not in use)
Main power switch for the unit.
5
This socket should be used for connecting your instrument to the amplifier. Only use a good quality screened cable.
Controls the volume level of the clean channel.
Controls the amount of bass or bottom end present on the clean channel.
Controls the amount of mid present on the clean channel.
Controls the amount of treble present on the clean channel.
Switch in to activate the overdrive ‘Crunch’ channel. When active, control the amount of distortion with and the overall
volume with
Indicates that the drive channel is active.
Controls the crunch channel gain, low down for classic rock and blues, higher up for hard rock and metal.... the higher you go
the more Extreme it gets. Use in conjunction with to get the overall level balanced how you want it.
Controls the overall level on the drive channel. Use with
eXtreme Tone Shaping. This applies a scooped mid tone shape to the drive channel and boosts certain key frequencies for a
unique sound.
Controls the amount of bass or bottom end present on the drive channel.
8
9
9
8
1
Page 6 /12
Page 7 /12
2
3
4
6
7
12
15
16
FRONT PANEL CONTROLS
Laney
OPERATING INSTRUCTIONS
Laney
OPERATING INSTRUCTIONS
1
2
3
4
8
17
20
6
16
7
17
18
10
11
12
13
14
18
19
13
19
20
5
9
15
8
9
10
11
14