Laney NEXUS-FET - Manual (Page 15)

Page 15 /20
Laney
OPERATING INSTRUCTIONS
Amplifier in Standby mode
Mute LED On
Input Level Meter Peaks
Easily
Check AC Power cord connected correctly,
Check AC Power cord plug fuse has not blown,
Check Thermal Trip on rear panel, Retry
Switch to Run mode, Retry.
If cooling fan is loud due to overheating,
check ventilation is clear, allow to cool, Retry.
Connect instrument or cabinet correctly, Retry
Reduce input gain, enable Pad, reduce excessive
Boost, Retry
If the problem is not covered above, or the steps lead you here, then contact
your Laney dealer who can help with servicing or information.
TROUBLESHOOTING DIAGRAM
Instrument/Cabinet Not
connected correctly
No Power Illumination
Enable a channel, Retry
No Sound or Bad Sound
X
F
N
E
T
F