Laney LA35C User Manual
Page 10
FRONT & REAR PANELS
1
2
3
4
5
6
7
8
MIC/AUX IN: XLR / Jack Combo Socket input has been designed to accept both balanced (XLR) and balanced or unbalanced
(6.3 Jack) signals. (Phantom power is also supplied with the signal through the balanced XLR if your mic uses it). A microphone,
keyboard, another guitar etc. can all be connected here. Good quality low impedance condenser or dynamic mics should preferably
be used for best results, these will ensure the best possible results from hand-held instruments or closely mic'd instruments.
VOLUME: Controls the volume level of Channel 1.
REVERB: When selected, applies reverb to Channel 1.
INSTRUMENT: XLR / Jack Combo Socket input: (both balanced (XLR) and balanced or unbalanced-6.3 Jack), connect your
guitar via this socket, use only good quality instrument cable.
PAD: The pad switch allows you to reduce (or pad down) the input level from a guitar with an active pickup system, or a
particularly loud passive pickup to prevent the guitar from overloading the preamplifier.
VOLUME: Controls the volume level of Channel 2.
EQ: The four band graphic equalizer allows you to easily modify your tone and effectively ‘see’ the response you are getting. There
are four sliders covering Low, Low-Mid, High-Mid, High in the 80Hz - 5KHz range. When the slider is in the central position the
signal at that frequency is unaffected or flat. Moving the slider up or down from the centre will Boost or Cut that frequency.
ANTI-FEEDBACK: Narrow notch filter operating on frequencies between 25Hz to 500Hz. Use the push switch to turn on.
15
1
2
3
5
6
11
4
12
13
14
7
8
9
10