Laney LT112 - Manual (Page 6)

In order to take full advantage of your new product and enjoy long and trouble-freeperformance, please read this owner's manual
carefully, and keep it in a safe place for future reference.
1). Unpacking: On unpacking your product please check carefully for any signs of damage that may have occured whilst in transit
from the Laney factory to your dealer. In the unlikely event that there has been damage, please repack your unit in it original carton
and consult your dealer. We strongly advise you to keep your original transit carton, since in the unlikely event that your unit should
develop a fault, you will be able to return it to you dealer for rectification securely packed.
2). Amplifier Connection: In order to avoid damage , it is advisable to establish and follow a pattern for turning on and off your
system. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc, BEFORE
turing on your bass amplifier. Many products have large transient surges at turn on and off which can cause damage to your speakers.
By turning on your bass amplifier LAST and making sure its level control is set to a minimum, any transients from other equipment
should not reach your loud speakers. Wait till all system parts have stabillised, usually a couple of seconds. Similarly when turning off
your system always turn down the level controls on your bass amplifier and then turn off its power before turning off other
equipment
3). Cables: Never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle
the amplifier load and could cause damage to your complete system.
4). Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel
General Instructions
This product conforms to the requirements of the following European Regulations, Directives & Rules:
CE Mark (93/68/EEC), Low Voltage 2006/95/EC, EMC (2004/108/EEC),
RoHS (EU2002/95/EC), WEEE (EU2002/96/EC)
---------------------------------------------------------------------------------
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal
household waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the
WEEE (Waste Electrical and Electronic Equipment) directive applicable in your country.
---------------------------------------------------------------------------------
In the interest of continued development, Laney reserves the right to amend product specification without prior notification.
6