Lanner LEC-2026 - Manual (Page 65)

LEC-2026
65
Lanner also provides sample code for bypass control with WDT via
programming. For sample code, look in the LAN_Bypass_Watchdog
directory under Driver and Manual CD.
Follow these procedures to run the program:
1. Compile source code on Linux platform first with the following
command:
# gcc wdbp.c -o wdbp
2. Execute the program:
#./wdbp
3. Commands:
Enable the bypass
# wdbp.exe –f
Set Watchdog Timer. This command will set the time interval at which
the counter will start count down.
# wdbp.exe -wl xxx (xxx: 1-255 sec for timer count down)
Reset Watchdog Timer. This command will reset the watchdog timer’s
counter and the bypass status to non-bypass.
#wdbp.exe -wr xxx (xxx: 1-255 sec for timer count down)