Lanner LEC-2110 - Manual (Page 21)

21
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Installing the Hard Disk
The system can accommodate one Serial-ATA disk. Follow
these steps to install a hard disk into the system:
Put hard disk on the bottom chassis and fix the hard disk 1.
on the chassis with 4 mounting screws as illustrated in
the following picture.
Plug the Serial-ATA cable to the hard disk.
2.
Connect the Serial-ATA power and data disk cables to 3.
the Serial-ATA power and disk connectors on the main
board respectively.
Close the cover and fix it firmly to the system with the
4.
screws.
1
2
3
Note: Using a PCIe or PCI riser card, users have
choice of either PCI or PCI Express 1x expansion:
1x PCI can be supported by model LEC-2110P 1.
1x PCIe can be supported by model LEC-2110E 2.
Both of PCI or PCIe support the Max. 3.
Dimension as the following illustrated and the
Max. PowerPower consumption reserved for
expansion is 10W.