Bang & Olufsen BeoPlay V1 User Guide - Manual (Page 42)

42
>> Software and service update
If you have connected, for example,
a set-top box to your television and a
Peripheral Unit Controller (PUC) table is
available for this set-top box from the
Internet, you can download the PUC
table and use your Beo4/Beo6 remote
control to operate your set-top box.
Normally you configure the source
when connected as explained
on
page 12 but you can also download a
PUC table later on.
Your television must be connected to
the Internet to download a PUC table.
For more information about PUC tables,
contact your retailer.
You can also delete PUC tables, however,
make sure not to delete tables currently
used by connected products.
Depending on your IR-controlled PUC equip-
ment, you may have to press SHIFT + 9 on
your Beo4, to switch on the equipment.
SHIFT can be found in the Beo4 LIST.
Download or remove PUC tables
MENU
SETUP
SERVICE
PUC MANAGEMENT
PUC DOWNLOAD
PUC CLEAN-UP